E21-TVS MII pocket controller
The E21-TVS MII pocket controller is developed with the ATEM Television Studio in mind. Therefore the two bus selection rows are laid out with 6 buttons. Each corresponds to the number of video input sources. There is a simple Cut and Auto button plus two “user buttons” you can dedicate to any particular function you wish.
We even squeezed in a slider to allow custom transition flows. In this new version we have improved the slider position to make it more flush with the panel surface. It’s now even possible to get power over ethernet (PoE). Furthermore the DB-25 connector with 2×8 channel I/O in this low height enclosure.
The form factor is sweet with all this functionality only taking up an inch in the height. By default the units are destined to control ATEM switchers, but you can control anything else we support with our list of protocol implementations. It’s all Open Source – as usual!
|Connections||Ethernet for direct connection between ATEM, or via network. DB25 connector for GPIO option|
|Power Requirement||12V External power supply or PoE|
|What’s Included||E21-TVS MII + PSU + network cable + programming cable|
|12.7 x 8 x 2.9 cm (enclosure size)|
With the GPIO option you get 2×8 channel I/O with the DB-25 connector. The DB-25 connector configuration is similar to the BlackMagic Design GPI & Tally Interface. Use the GPO to provide tally and the GPI to trigger a action with a foot pedal, a switch or something similar. The behaviour of the GPIO can be fully controlled from the UniSketch web interface. The GPIO module will not be fitted, if this option is not selected.
With the Power over Ethernet option you can communicate and power the E21-TVS MII with a single cable (PoE compatible switch/hub required).
The E21-TVS MII pocket controller is compatible with following systems:
- AJA Kumo,
- BlackMagic Design HyperDeck,
- BlackMagic Design SmartScope
- BlackMagic Design VideoHub.